This is a complete GPS module based on NEO6M. The device uses the latest technology to provide the best possible location information and features a larger integrated 25x25mm active GPS antenna with a UARTTTL jack. It also includes a battery to help speed up your GPS connection. This is an updated GPS module available in ardupilotmega v2. This GPS module provides the best possible location information and improves performance on Ardupilot or other multirotor control platforms.
The NEO6M GPS engine on this board is very good with high precision binary output. It is also highly sensitive for indoor use. The NEO6M GPS module has a battery for backup power and an EEPROM for storing configuration settings. Since the antenna is connected to the module via a UFL cable, the GPS can be flexibly mounted so that the antenna is always facing the sky for best performance. This makes it powerful for use in cars and other mobile applications. The
GPS module has a TTL serial output and has four pins: TX, RX, VCC and GND. You can download the ucenter software to configure GPS, change settings, and more.
Features : GY-9960-3.3 APDS-9960 RGB
- 5Hz position update rate
- Operating temperature range: -40 TO 85°CUART TTL socket
- EEPROM to save configuration settings
- Rechargeable battery for Backup
- The cold start time of 38 s and Hot start time of 1 s
- Supply voltage: 3.3 V
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600)
- SuperSense ® Indoor GPS: -162 dBm tracking sensitivity
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN)
- Separated 18X18mm GPS antenna
